SILIONIC® Ionic colloidal silver 100 ppm - 500 ml

100 ppm - 500 ml

Manufacturer states:

SILIONIC® - Highly pure ionic colloidal silver with a high proportion of positively charged ions.

NEW: Silionic® has an improved effect due to the higher content of silver ions. Silionic® shows a stronger colouring and in tests a more pronounced metallic taste. 

By using the distilled water aquaionic® the tendency of the silver to adhere is reduced, so that more elemental silver remains in the solution. Silionic® - colloidal silver therefore exhibits a stronger colouring.
Important: The ion–particle ratio shifts in favour of the silver ions, which in our tests resulted in a stronger metallic taste. The higher proportion of active silver ions leads to increased efficacy.

Silionic® - ionic colloidal silver produced in the company laboratory
Ionic colloidal silver under the brand name Silionic® has a higher proportion of active positively charged silver ions! Colloidal silver solutions from Medionic® contain no additives!
Since 2002 we have been producing silver solutions of the highest quality. The resulting extensive experience enables us to produce highly pure (i.e. without additives) colloidal silver in different concentrations — with an optimal ratio of positively charged ions to particles.

Why do we call it "ionic colloidal silver"?
The actually active component of any silver solution are positively charged silver ions (cations), which are always present in electrolytically produced silver solutions. Experiments in earlier years showed that pure colloidal silver, made by stirring silver powder into water, produces almost no effects. In contrast, almost all medical and technical research is focused on the action of silver ions.
The term "ionic colloidal silver" or colloidal silver solution was already coined in the late 1990s by the developer of the Ionic-Pulser®. Similar references can be found in many books, e.g. by J. Pies, as well as throughout the specialist literature.
The particles (colloidal particles) merely serve to release silver ions, but the amount released is in many cases far too small for optimal effect. Therefore the proportion of positively charged silver ions should be as high as possible even in the fresh solution.

Shelf life: In principle colloidal silver cannot go bad, as germs do not survive in silver water. However, its effect gradually diminishes from the outset. This behaviour is partly due to the decreasing particle charge. On the other hand, partial deposits of silver on the walls of the container can occur, which of course leads to concentration losses. It is therefore obvious to use as fresh dispersions as possible. With proper storage usable for at least 6 months. After that it is advisable either to use a fresh silver solution or to increase the amount used accordingly.

Storage: Finished colloidal silver should primarily be protected from electromagnetic fields. So do not put it in the refrigerator or on a loudspeaker or computer, etc.
Protection against radiation such as mobile phone signals, radar etc. is basically hardly possible. However, no negative influence in this respect has been observed so far.
Furthermore, protection from incident light, especially sunlight, is important. Short-term exposure does little harm.
It does not matter whether colloidal silver is stored in amber glass bottles or in clear glass bottles with a light shield of cardboard or in any other form.
It is also important to store colloidal silver reasonably cool. A cellar would be ideal, but storage at room temperature is usually sufficient.

Note: The stated amount of silver is the amount of silver released into the solution. This may differ from the actual silver content, as losses of silver adhering to surfaces during and after production cannot be calculated and therefore cannot be taken into account.